ADT-HC4500 Flame/Plasma Cutting Machine CNC System
- 43 -
1.2.2.3 Clear
In the manual interface, press [F5] to clear the parameters in memory; if you press [X] or [Y]
[F5] (Clear)
[OK], the X, Y coordinates of the entire line will be cleared; to clear the last digit only, press [DEL] on the panel.
1.2.2.4 Returning reference point
In the manual interface, press [F6] to return X, Y coordinates in the manual interface to the reference coordinates.
1.2.2.5 X/Y coordinates setting
In the manual interface, press [X], [Y] on the panel to modify or clear X, Y values.
Press [X], [Y] to show current coordinates in the lower left of the interface, e.g. “Enter X: X=+00123.456”; at this
moment, you can press [DEL] to clear the coordinates, press [F5] (Clear) to clear the entire line; press [OK] after
setting above values.
1.2.3 Backward
In Auto manual, this function is used to back the plate along original track if it isn’t cut through. Follow the
procedures below:
During automatic processing, press [Stop] to stop running
press [F3] (Back) to backing function
while
backing, press [Stop] when it reaches desired position
press [F1] (Run idle) to move forward if it backed in
excess
press [Start] again when the system is stable, and the system runs M07 perforating instruction again and
processes according to the program.
The plate only can be backed to previous perforating hole.
1.2.4 Forward
In Auto interface, if you press [Stop] to stop running while processing, run idle or backing, the “Manual” menu
will turn into “Forward”; if you press [F2] at this moment, the system goes forward at actual processing speed and
doesn’t run M switch instruction, equivalent to running idle at processing speed.
1.2.5 Graphics processing function
In the graphics interface as in Fig. 3.1.2.5, press [F4] (Process) to enter graphics processing interface, as in
