Adtec edje 4111 HD, Operation Manual

Page: 13 / 42

11 Chapter 2 - Player & Server Installation
BNC video outputs. Therefore to view video on the composite BNC
output port, select one of the NTSC or PAL display targets. All the other
resolutions are appropriate for the DVI output.
3. Setup NTP Server (optional)
If you will be doing scheduled playback of content, it is
recommended to configure the server to an NTP network time server as
follows:
- Press the “Mode” button until the SYSTEM MENU is displayed, then press
“Select”.
- Press the Down arrow until the NTP MENU is displayed, then press
“Select”.
- Press the Down arrow until the NTP Server IPA item is shown. Enter the
IP address of the NTP server using the “Select” and arrow buttons, then
press “Enter” to save. Note: Entering 0.0.0.0 as the IPA will cause the
server to synchronize with its own time.
4. Make Cable Connections
Unplug the Soloist and make the following cable connections for
your setup:
Video: Connect your monitor to either the DVI connector or the composite
BNC connector using the 7 pin media port adapter included with the
Soloist.
Audio: Connect to either the 1/8” unbalanced analog audio port or the
S/PDIF digital audio RCA port on the 7 pin media port adapter cable.
Ethernet: Connect an Ethernet cable to the Ethernet port for external
control by mediaControl.
GIGE: Optionally connect the GIGE port to your IP Multicast network. Note
that the control network and the multicast network must be on separate
unique subnets.
Plug in the Soloist 4111HD and confirm that the IP address is
correct on your unit and that the Link LED on the front of the unit is lit
before installing the mediaControl application.