– 7 –
Using a 7720P Programming Tool
After the GSMVLP-ADT has been installed in the ADT QuickConnect 3000, connect the 7720P
Programming Tool as shown in Figure 5. The GSMVLP-ADT powers the 7720P Programming Tool via
the programming jack. Each key of the 7720P has two possible functions: a normal function and a Shift
function.
•
To perform a normal key function, simply press the desired key.
•
To perform a Shift function, press the [shift] key, and then press the appropriate key.
The prompts in this document reflect use of the 7720P Programming Tool. Table 1 lists each normal
and shift key function.
7720P PROGRAMMING JACK
MESSAGE STATUS LEDs
MINIMUM SIGNAL STRENGTH LED
TEST
MESSAGE/REGISTRATION
SWITCH
GSMVLP-004-V0
A
B
C
D
E
F
S
T
X
Xmit
Shift
Space
Enter
Shift
N / Y
BS / ESC
/
7720 PROGRAMMING TOOL
#
0
1
2
3
4
5
6
9
8
7
Figure 5 – 7720P Connection
Table 1 – 7720P Normal and Shift Key (shift LED lit) Functions
KEY
NORMAL KEY FUNCTION
SHIFT KEY FUNCTION
BS/ESC
[BS]: Press to delete entry
[ESC]: Press to quit program mode; also can reset
programming defaults*
↓
/
↑
[
↓
]: Scroll down programming
[
↑
]: Scroll up programming
N/Y
[N]: Press for "NO" answer
[Y]: Press SHIFT-Y for "YES" answer
SHIFT
Press before pressing a SHIFT key function. Will light SHIFT LED. LED goes out once a key is pressed.
Press again for each SHIFT function desired.
1/A
[1]: For entering the number 1
[A]: For entering letter A
2/B
[2]: For entering the number 2
[B]: For entering letter B
3/C
[3]: For entering the number 3
[C]: For entering letter C
4/D
[4]: For entering the number 4
[D]: For entering letter D
5/E
[5]: For entering the number 5
[E]: For entering letter E
6/F
[6]: For entering the number 6
[F]: For entering letter F
7/S
[7]: For entering the number 7
[S]: For entering letter S
8/T
[8]: For entering the number 8
[T]: For entering letter T
9/X
[9]: For entering the number 9
[X]: For entering letter X
SPACE
[SPACE]: For scrolling option list
No SHIFT function
0
[0]: For entering the number 0
No SHIFT function
#/ENTER
[#/ENTER]: Starts programming
mode; Press to accept entries
No SHIFT function
*Active only when the "Exit Programming Mode" prompt is displayed.
