– 5 –
BACK
CASE
GSMVLP-002-V0
TAPE
TIE WRAP
MOUNT
FRONT
CASE
LOCKING TABS
SCREW
(3)
GSMVLP
ECP/POWER
CABLE
Figure 3 – Installing the GSMVLP-ADT Module
3. Install the control in accordance with the ADT QuickConnect 3000 Installation Instructions.
4. Install the GSMVLP-ADT into the control’s back case and secure it with the three provided screws.
Refer to Figure 3.
For best radio performance, the wires, ECP/power cable and shielded audio cable must be
routed as shown in Figure 4.
5. Connect the provided ECP/power cable between the GSMVLP-ADT module and the PC board and
route the cable as shown in Figure 4. This cable provides DC power and ground for the module
and ECP connections.
6. Make the wiring connections and install the control in accordance with the ADT QuickConnect
3000 Installation Instructions.
7. Remove the backing from the tape on the provided tie wrap mount. Install the tie wrap mount in
the lower right side of the back case as shown on Figure 3.
!
Do not block the ventilation slots in the case when installing the tie wrap mount.
8. Secure the wiring with the provided tie wrap as shown in Figure 4.
9. Program the GSMVLP-ADT. Refer to the Programming the GSMVLP-ADT Module section.
10. Connect the provided shielded audio cable between the GSMVLP-ADT module and the PC board
and route the cable as shown in Figure 4.
11. Once all programming is completed, snap the control front assembly to the back case.
