ADLINK Technology Q7-AL, User Manual

Page: 39 / 95

Q7-AL
Connector Pinouts on Module
29
4. Connector Pinouts on Module
This chapter describes connectors, LEDs, and switches that are used on the module.
4.1. Connector, Switch, and LED Locations
Figure 7: Q7-AL Connector, Switch and LED Locations
4.2. Q7-AL and the DB40 Debug Module
The DB40 debug board can be connected via a FPC 40-pin flat cable to the module. It provides bus extensions to the SPI bus
(out of band BIOS flashing) and the BMC (access to Board Management Controller). It also can be used to show BIOS POST
CODE Display 80/81h (on LPC) and it provides Test Points with Signaling LEDs

PWRBTN

SYS_RESET#

CB_RESET#

CB_PWROK

SUS_S3#

SUS_S4#

SUS_S5#
Moreover there is a PWRBTN / SYS_RESET switch and a BIOS Mode Selection: Failsafe.