38
•
BIOS Configuration
The system supports five modes, numbered from 0 (default) to 4, which
primarily differ in timing. When Auto is selected, the BIOS will select the
best available mode.
Auto<Default>
Auto select which mode that BIOS
communicates with the controller and CPU
Mode0~Mode4
User define the PIO mode
IDE Primary/Secondary Master/Slave UDMA
These fields allow your system to improve disk I/O throughput to 33Mb/sec
with the Ultra DMA/33 feature. The options are
Auto<Default>
and
Disabled
.
USB Controller
Select
Enabled
if your system contains a Universal Serial Bus(USB)
controller and you have USB peripherals. The default is
Enabled
.
USB Keyboard Support
Select
Enabled
if your system contains a Universal Serial Bus (USB)
controller and you have a USB keyboard.
Init Display First
This item allows you to decide to activate whether PCI Slot or on-chip VGA
first. The default is
PCI Slot
.
IDE HDD Block Mode
This field allows your hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
Enabled
IDE controller uses block mode
Disabled<Default>
IDE controller uses standard mode
Onboard FDC Controller
Select
Enabled
if your system has a floppy disk controller (FDC) installed on
the system and you wish to use it. If you install an add-in FDC or the system
has no floppy drive, select Disabled in this field. This option allows you to
select the onboard FDD port.
Onboard Serial Port 1/2
These fields allow you to select the onboard serial ports and their addresses.
The default values for these ports are:
Serial Port 1
3F8/IRQ4
Serial Port 2
2F8/IRQ3
Summary of Contents for NuPRO-775 Series
