BIOS Configuration
•
29
IDE Primary/Secondary Master/Slave
Auto <Default>
Bios will auto detect the hard disk type.
Manual
User can assigns the type of hard disk when the
access mode is normal.
None
Selects this selection when there is no hard disk in
the system.
Access Mode
Auto <Default>
Auto-detect the HDD mode
Normal
HD < 528MB
Large
For MS-DOS only
LBA
HD > 528MB and supports Logical Block Addressing
If your hard disk drive type is not matched or listed, you can use normal
access mode to define your own drive type manually. If you select normal
access mode, related information is asked to be entered to the following
items.
Cylinder
Number of cylinders
Head
Number of read/write heads
Precomp
Write precompensation
Landing Zone
Landing zone
Sector
Number of sectors
Note:
The specifications of your drive must match with the drive table.
The hard disk will not work properly if you enter incorrect
information in these fields.
The
Capacity
items automatically adjust according to the configuration.
Drive A / Drive B
These fields identify the types of floppy disk drive A or drive B that has been
installed in the computer. The available specifications are:
None
No floppy drive be installed
360KB 5.25 in.
5.25 inch floppy drive, 360KB capacity
1.2MB 5.25 in.
5.25 in. floppy drive, 1.2MB capacity
720KB 3.5 in.
3.5 in. floppy drive, 720KB capacity
1.44MB 3.5 in.<Default>
3.5 in. floppy drive, 1.44MB capacity
2.88MB 3.5 in.
3.5 in. floppy drive, 2.88MB capacity
Summary of Contents for NuPRO-775 Series
