ADLINK Technology DLAP-3000 Series, User Manual, Page: 38 / 141

28 System Layout
Leading
EDGE COMPUTING
3.1.2 Audio Connectors (DLAP-3100-CF only)
The DLAP-3100-CF provides the following defualt audio connectors.
X
3.5 mm mono jack for left channel speaker out (6W)
X
3.5 mm mono jack for right channel speaker out (6W)
X
Microphone in
The following audio configurations are also available.
X
Mic-in, Line-out, Line-in
X
Line-in, L/R speaker-out (6W + 6W)
M1
Alarm Reset Button
: When the fan or GPU temperature alarm has been
triggered, insert a small, thin object like a paper clip and press the reset
button to turn off the alarm. This is to reset the alarm beeper only, not to
reset the alarm LED.
M2 Reset Switch
: Push to reset the system.
M3
Power On Button
: Lights blue when the system is powered on, blinks
when the system suspends to RAM, and is off when the system suspends
to disk.
M4
Remote Power On Button Connector
(MPN: ALEX ALEX, 9553-02-PBT,
BLACK): Remote power on control.
Note
: Requires additional cable with an ALEX 9566-02G tin plated
connector. The left pin is GND and the right pin is PRWBTN#, short
enabled.
M5 Temperature Alarm LED
: Blinks white when CPU or GPU overheats.
M6 Fan Alarm LED
: Blinks amber when CPU, GPU, or system fan is <300 rpm.
M7 Storage Status LED
: Blinks red when storage is accessed.
NOTE:
NOTE:
The DLAP-3100-CF series audio connectors are (from top to
bottom) speaker out L channel (6W), speaker out R channel
(6W), and Mic in. The speaker out connector should be a
3.5mm mono jack plug. If a line out (headphone out) is needed
instead of the speaker out (with amplifier 6W+6W), contact
your local ADLINK sales representative.