ADLINK Technology AMP-304C, User Manual, Page: 21 / 63

Getting Started 11
AMP-304C
2.3 Hardware and Software Driver Installation
2.3.1 Hardware Configuration
The AMP-304C is fully Plug-and-Play compliant and can be
installed in any PCI Express slot. It employs a PCI Express Gen1
x1 bus, and the system BIOS can auto-configure memory and IRQ
channels.
ADLINK’s exclusive DIN-304C terminal board provides an easy-
to-use set to connect to external drivers and to fulfill extra func-
tions.
2.3.2 Installation Procedures
1. Read through this manual and setup the switches,
jumper and I/O signals according to your application.
2. Turn off the computer and all relevant terminal boards,
and install the AMP-304C in any available PCI Express
x1/x4/x8/x16 slot. Make sure you have proper ESD
(Electrostatic discharge) protection.
3. Connect the AMP-304C and DIN-304C with the
ACL-10569 (68-pin SCSI-II), or 2 sets of ACL-10137 (37-
pin D-SUB) and ACL-10437 cables.
4. Set up servo or stepper drive connection as well as
mechanical signals, servo interface signals, switches and
jumpers settings, GPIO and any essential drive signals.
5. Turn on the system power including computer power,
terminal board power, and 24V DC power.
6. Verify all signals and servo operation via MotionCreatorPro2.