ADIC VLS AIT, Installation And Operating Manual, Page: 58 / 90

44 Troubleshooting and Diagnostics
VLS Error Messages
If any component of the VLS is not communicating correctly, a warning message will appear
on the front display.
A list of error messages follows below. If the error you see is not on this list, please call
ADIC’s Customer Assistance Center.
In all cases, after removing the cause of the problem (or if you can't find a cause) push
MENU
to return the VLS to the on-line condition.
If the error message is not listed, try to return to the on-line mode by pressing ALT and/or
ENTER . If that does not work or if you get the error again, call ADIC’s Customer Assistance
Center and be prepared to tell them what the error message is – and what the conditions are.
Error Messages
Note
C_]U _b Q\\ _V dXU Ubb_b ]UccQWUc ]Qi bUce\d Vb_] _^U _b ]_bU
S_^TYdY_^c DXU TUVY^YdY_^ WYfU^ Yc V_b Q cY^W\U S_^TYdY_^ _^\i 9V i_e
RU\YUfU dXQd dXU S_^TYdY_^ gXYSX SQecUT i_eb Ubb_b ]UccQWU Yc _dXUb
dXQ^ dXU TUVY^YdY_^ `\UQcU SQ\\ 1493 DUSX^YSQ\ 1ccYcdQ^SU 3U^dUb
1D13 Qd* ( ("'#(""
Error Name Description
Source location empty
The source location was empty when the VLS attempted to pick
a cartridge from it.
Destination location full The destination location was full when the VLS attempted to
place a cartridge in it.
Mag unload disabled by
software The application has issued the SCSI PREVENT/ALLOW
MEDIA REMOVAL
command, preventing the magazine from
being unloaded.
Can’t unload, media in
drive
The VLS will unload the magazine only if all drives are empty.