Industrial
Electronic Devices
ADFweb.com S.r.l.
User Manual
EtherCAT Slave / CANopen
Document code: MN67E08_ENG Revision 1.000 Page 28 of 32
Note:
When you receive the device, for the first time, you also have to update the Firmware in the HD67E08 device.
Warning:
If Fig. 9 appears when you try to do the Update try these points before seeking
assistance:
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
Check the LAN settings;
If you are using the program inside a Virtual Machine, try to use in the main
Operating System;
If you are using Windows Seven, Vista, 8 or 10 make sure that you have the
administrator privileges;
In case you have to program more than one device, using the "UDP Update", you
have to cancel the ARP table every time you connect a new device on Ethernet. For
do this you have to launch the "Command Prompt" and write the command "arp -
d". Pay attention that with Windows Vista, Seven, 8, 10 you have to launch the
"Command Prompt" with Administrator Rights;
Pay attention at Firewall lock.
Warning:
In the case of HD67E08 you have to use the software “HD67E08”:
www.adfweb.com\download\filefold\SW67E08.zip
.
Figure 9: “Error” window
