Adey MagnaClean CMX, Installation And Servicing

Page: 9 / 24

9
7. Controller Programming Parameters
PROGRAMMING MODES
1.
Press ‘UP’ & ‘DOWN’ , (Buttons 1 & 3) for 3 seconds to enter TIME & DATE PROGRAMMING MODE
a) Press ‘UP’ , (Button 1) to increase the value
b) Press
‘DOWN’
, (Button 3) to decrease the value
c) Press ‘SET’ to confirm and move to the next value
d) To exit time & date programming mode, press and hold the ‘SET’ button.
2. Press ‘SET’ . (Button 4) for 3 seconds to enter PARAMETER PROGRAMMING MODE and enter the
access code, ‘111’ .
a) Press
‘UP’
, (Button 1) to increase the value
b) Press ‘DOWN’ , (Button 3) to decrease the value
c) Press ‘SET’ , (Button 4) to enter the password value during password request and to save any
parameter changes
d) To cycle through the controller parameters, HOLD ‘SET’ followed by ‘UP’ , (Button 4 & 1) to move
to the next parameter; HOLD ‘SET’ followed by ‘DOWN’ , (Button 4 & 3) to move to the previous
parameter.
e) Press
‘MUTE’
, (Button 2) to reset the pump hours counter.
f) To exit parameter programming mode, press and hold the ‘SET’ button.
CONTROLLER PARAMETERS
#
Parameter Description
Default Range
-
Service Date Adjust future service date: Day/Month/Year.
Press & hold ‘SET’ to cycle across values. Will
pass onto next parameter once complete
- -
-
Last Service
Date Automatically updates when a new service date
has been entered and will be visible next time
user accesses parameters
- -
1
Cartridge*
Present Monitors presence of a filter cartridge
No Yes/No
2
Magnet Only**
Service Warning Daily/weekly/monthly warning alarm
Daily
Daily
Weekly
Monthly
3
Magnet Only
Service Warning
Duration Number of days/weeks/months (unit
representation dependent upon Parameter 2
Alarm choice - Daily, Weekly or Monthly)
2 1-12
4
Pressure
Difference
Warning Warning trigger point based on pressure
differential output (The default value of 0.4 bar
should not be changed)
0.4
0.1 - 2.5
bar
5
Pressure
Difference Alarm Alarm trigger point based on pressure differential
output (The default value of 0.6 bar should not be
changed)
0.6
0.1 - 2.5
bar
6
Sensor Minimum
Pressure Minimum pressure value of sensor (The default
value of 0.0 bar should not be changed)
0.0 bar
0 - 2.5
bar
7
Sensor Maximum
Pressure Maximum pressure value of sensor (The default
value of 2.5 bar should not be changed)
2.5 bar
0 - 2.5
bar