– 28 –
Device Programming
This menu is used to program keypads, receivers and relay modules.
From Data Field Programming Mode, press #93 to display "ZONE PROG?". Press 0 repeatedly to display "DEVICE PROG?".
DEVICE PROG?
1=YES 0=NO
Press 1 to enter
Device Programming.
DEVICE ADDRESS
01-31, 00=QUIT
The device address identifies the device to the control. Enter the 2-digit device address
number to match the device's physical address setting (01-30).
Press [
✱
] to accept entry.
Note: Device Address 04 must be used for the 4285/4286 Voice Module, if one is installed.
If not, it can be used for another device type.
Device Address 00 is always set as an alpha keypad assigned to Partition 1 with no sounder suppression
options, and these settings cannot be changed.
DEVICE TYPE
Select the type of addressable device as follows:
0 = device not used
1 = alpha keypad (6139/6139R)
3 = RF receiver (5881)
4 = output relay module (4204/4204CF)
5 = Voice (VIP) Module (4285/4286)
6 = Long Range Radio
8 = Fire Display
9 = Vista Gateway Module (VGM)
Press [
✱
] to accept entry.
Alpha Keypad
CONSOLE PART.
If device type 1 (alpha keypad) is selected, this prompt will appear. Enter the addressable
device's default partition number (01 to maximum number of partitions programmed for
system in field 2*00). This is the primary partition for which the device is intended to be
used. Enter 9 to make this keypad a "master" keypad for the system.
Press [
✱
] to accept entry.
SOUND OPTION
If device type 1 (alpha keypad) is entered, this prompt will appear. Keypads can be
individually programmed to suppress arm/disarm beeps, entry/exit beeps and chime mode
beeps. This helps prevent unwanted sounds from disturbing users in other areas of the
premises.
Enter a number 00-03 for the keypad sounding suppression options desired for the keypad
as follows:
00 = no suppression.
01 = suppress arm/disarm & entry/exit beeps.
02 = suppress chime mode beeps only.
03 = suppress arm/disarm, entry/exit and chime mode beeps.
Press [
✱
] to accept entry.
KEYPAD GLBL?
If device type 1 (alpha keypad) is entered, this prompt will appear. Each keypad can give
users with access to multiple partitions the ability to arm and disarm those partitions from it.
To enable this keypad for global arming/disarming, enter 1. To prevent the ability to use
this keypad for global arming/disarming, enter 0.
Press [
✱
] to accept entry.
RF Expander
RF EXPANDER
HOUSE ID XX
If device type 3 (RF Receiver) is selected, this prompt will appear. Enter the 2-digit House
ID (00-31). This is required if using a wireless keypad (5827/5827BD).
Press [
✱
] to accept entry.
www.PDF-Zoo.com
