–
13
–
RLY VOICE DESCR?
1 = YES 0 = NO
For entering voice descriptors for relays to be used with the 4285/4286 VIP Module.
CUSTOM INDEX ?
1 = YES 0 = NO
For creating custom word substitutes for VIP Module annunciation.
ACCESS POINT PGM
1 = YES 0 = NO
For defining the parameters for each of the VistaKey access point including which group(s)
have access through an access point (door). See the
VistaKey-SK Installation and Setup
Guide for the detailed programming instructions.
ACCESS GRP PGM
1 = YES 0 = NO
For defining the capabilities (privileges) for each group of users. See the
VistaKey-SK
Installation and Setup Guide for the detailed programming instructions.
EVENT/ACTION PGM
1 = YES 0 = NO
For defining events and time windows for an access group. See the
VistaKey-SK Installation
and Setup Guide for the detailed programming instructions.
Zone Programming
ZONE PROG?
1=YES 0=NO
Press 1 to enter ZONE PROGRAMMING mode. The following screens will appear. Press [
✳
] to
display the next screen. Press # to display a previous screen.
SET TO CONFIRM?
0 = NO 1 = YES 0
This prompt will appear once upon entering Zone Programming.
If “Yes,” Confirmation prompts will be displayed after the device’s Serial and Loop numbers
have been entered later.
ENTER ZONE NO.
000 = QUIT
010
Zone 010 entered
↑
Enter the 3-digit zone number to be programmed, as follows:
Protection Zones = 001–032
Relay Zones = 601–616.
ECP Device Supervisory Zones = 800–831.
System Supervisory Zones = 988, 990, 992 (duress), 997 Keypad Panic Zones = 995, 996,
999.
Press [
✱
] to continue.
010 ZT P RC In L
0 0 1 1 0 0 0 1
This display will appear, showing a summary of the zone's current programming. ZT = Zone
Type, P = Partition, RC = Report Code, B = Bell/Aux. Relay assignment for zone, In = the input
type of device, and L = the device's loop number to which the sensor is connected.
Some devices can support more than one zone by means of individual loops (for example,
5801, 5804, 5816, 5817, etc.). If the zone is not programmed, the display will appear as
shown here. If checking a zone's programming, and it is programmed satisfactorily, press [#]
to back up one step and enter another zone number, if desired.
Press [
✱
] to continue.
www.PDF-Zoo.com
