ADEMCO 4286 - Ademco Phone Module, User Manual

Page: 29 / 36

25
Programming Speaker Output Mode
About the Speaker Output
Pressing
“
✴ ✴
”
on the monitored keypad will trigger a status
announcement from the speaker output (except if you have selected
the MUTE speaker control menu selection). User command
confirmation for Entry/Exit, Alarm, and other warnings can also be
provided.
If your installer connected an external speaker to the control you
must program the speaker output. To do this:
1. Obtain phone access with phone code/user code, as required. Be
sure to wait for arming status announcement to end before
continuing.
2. Press # 97 on phone keypad.
A menu will be announced, which is shown below. Press “1” or “0” in
response to the prompt. The prompt will be repeated after several
seconds without a key being pressed in response. To exit speaker
control programming, complete all required entries or hang up the
phone. If the phone is hung up before the Phone Module announces
“Exiting”, then any changes made will be lost. If a key other than “1”
or “0” is pressed, a buzzer sound will be generated in the phone
handset, and the menu request will be repeated.
Voice Menu for Programming Speaker Output Mode:
SPEAKER CONTROL
CATEGORIES
DESCRIPTION
MUTE:
1 = Yes, 0 = No
Disables all possible speaker output including those sounds listed
below. It will also disable the status announcement provided when
the
“
✴
”
key is pressed twice on the monitored keypad. It will not
mute certain panel synthesized phone commands that the control
directs to the speaker, such as transmitter learn mode speaker
output. If “1” is pressed, the system will announce “Exiting,” and
exit speaker output mode.
ALL ON: 1 = Yes, 0 = No
Enables all sound categories. If “1” is pressed, the system will
announce “Exiting”, and exit speaker output mode.