ADEMCO 4286 - Ademco Phone Module, User Manual

Page: 14 / 36

10
Typical System Command Entries
Command Function Entry To Be Keyed On Phone
QUICK-ARM To arm STAY System Security code + key [3].
FEATURE To arm AWAY System Security code + key [2].
AVAILABLE *
To arm INSTANT System Security code + key [7].
Yes No To arm MAXIMUM System Security code + key [4].
To BYPASS by specific zone
System Security Code + key [6] + zone # to
be bypassed (01, 02, 03, etc.).
To QUICK BYPASS all open
zones Refer to your system's User Guide.
To enable SPEAKER
OUTPUT
Press [# 97]. Phone menu follows
requesting a [1] or [0] to enable types of
speaker response.
Yes No To trigger PANIC alarm At any on-premises phone: Enter 2-digit
phone code followed by at least 6 ones [1]’s
until the panic alarm occurs.
ENTRY AND To DISARM System Security Code + key [1].
DELETION OF
TEMPORARY
To enter a TEMPORARY
CODE ** Master Security Code + key [8] + User No.
+ Temporary
Code.
CODES
VIA THE PHONE
To delete a TEMPORARY
CODE ** Master Security Code + key [8] + User No.
+ Master Security Code.
AVAILABLE To Turn CHIME mode on System Security Code + key [9].
Yes No To Turn CHIME mode off System Security Code + key [9] again.
To enter TEST mode System Security Code + key [5]. (on-
premises phone only)
To exit TEST mode
System Security Code + key [1].
* The "Quick-Arm" feature, if programmed by your installer (see boxes at
upper left in above table), will permit the use of the # key in place of your
4-digit system security code when arming the system.
**
This function cannot be performed via the phone with some systems.
See boxes at lower left in above table– your installer should have
indicated whether your system can perform this function.