12
Example of a Call-In From Outside
The following is an example of a complete sequence for a call-in from outside
to make sure that the security system was armed AWAY before leaving the
premises.
Assume that the 2-digit Phone Code is 7
✴
,
and that the system security code
is 1–2–3–4.
No answering machine is connected in the following example.
1.
Caller dials the premises phone number. After a programmed number of
rings, the caller will hear 2 long tones followed by a "click", and then the
words, "HELLO, ENTER PHONE CODE NOW.”
2.
Caller then enters the Phone Code:
7
+
✴
.
3.
The words "ENTER SYSTEM CODE NOW" will be heard.
4.
Caller then enters the system 4-digit system security code:
1 + 2 + 3 + 4
5.
The system will now start to annunciate a status report. If, when the
Arming Status is annunciated, the caller hears the words "DISARMED
READY TO ARM," the caller knows that the system was not armed.
6.
The status report may be interrupted at this point to enter an arming
command. * This must be done during a 1-second pause placed by the
Phone Module between each phone message. Do NOT make entries
while the system is speaking.
*
The command can also be entered immediately following the status
report.
To arm the system AWAY, the caller enters the 4-digit system security
code, then presses key 2 (AWAY) .
7.
If arming AWAY was successful, the caller will hear 2 confirmation
beeps, followed by the words: "ARMED AWAY... EXIT NOW.”
8.
The caller may hang up now, or wait approximately 20 seconds, at which
time the word "GOODBYE" will be heard to signify termination of the
phone access session.
Summary of Contents for 4286 - Ademco Phone Module
Page 2: ...i...
