ADB Safegate EREL, User Manual

Page: 26 / 50

Prepare to install
1. Make sure that all the parts are clean.
2. Pay special attention to the parts where the gasket must fit.
3. Assemble the complete optical head. See
Assemble the complete optical head .
Install - Step 1
1. Install the new gasket (A). Make sure that the side marked ‘THIS SIDE TO CENTRE LINE’ is at the side that corresponds with
the arrow on the optical head.
2. Connect the cable leads to the connectors (B): ‘IN1’ and ‘IN2’.
3. If you use an Earthing wire, connect it to the connector (C): ‘PE’.
Install - Step 2
1. Put the complete optical head (A) on the support (B).
2. Make sure that the rims (C) fit into the gaps (D).
3. Make sure that the arrow (E) points to the center of the runway.
4. Close the clamps (F) of the body support clip: I to III. Make sure that the rim (G) of the optical head is completely inside
the rims of the body support clip.
Warning
The body support clip must tighten the optical head to avoid risk of FOD caused by a loose head assembly.
5. Install the safety pins (H): IV.
6. Verify that the light turns on when powered.
CAUTION
Do not damage the cable lead.
EREL / ERES
Maintenance
20
Copyright
©
ADB Safegate, All Rights Reserved