ADB Safegate CRE 10, Installation Manual

Page: 48 / 86

48 A.07.370e - Edition 2.0
Pre-installation
5.2.7 Disconnection devices
1. Install a separate disconnection device for the input and output power, according to these standards:
- FAA: AC 150/5345-10F and L829;
- IEC: IEC 61822.
5.3 Prepare lightning protection
1. Examine the need for additional lightning protection.
2. If you need additional lightning protection, contact ADB Safegate to supply lightning diverters in
accordance with IEC 61822.
5.4 Install power supply
1. Install a power supply for each equipment.
2. Make sure the protection devices are correct. See also § 5.2.5, 5.2.6 and 5.2.7.
5.5 Plan cables and lay-out of cables
5.5.1 Procedure
1. Plan the routing of the cables so that the power cables and remote control cables are separated from
each other.
2. Plan the cable slack. See § 5.5.3, § 5.5.4 or § 5.5.2.
3. Plan the power supply cables and earthing cables. See § 5.5.5.
4. Plan the cables to the remote control interface (option). See § 5.5.6.
5. Plan the cables for the series circuit. See § 5.5.7.
5.5.2 Plan the cable slack, stackable cabinet
1. Plan the cable slack:
The cable slack from the bottom to the top of the cabinet:
- X: maximum 250 mm for the input power supply.
- Y: maximum 300 mm for the output power supply.
- Z: maximum 400 mm for the remote control cables.
5.5.3 Plan the cable slack, big and small cabinet
1. Plan the cable slack:
Required cable slack from the bottom to the top of the
cabinet:
- X: maximum 1000 mm for the input power supply.
- Y: maximum 1000 mm for the output power supply.
- Z: maximum 1500 mm for the remote control cables.
X Y Z
X
Y
Z
X
Y
Z