4-5
Installing the Device Driver
Installing the Driver When Windows Me is Already Installed
To install the Adaptec ATA RAID 1200A driver if Windows Me is
already installed, follow these steps:
1
Start Windows Me.
Windows Me will automatically discover the new hardware
and start the Found New Hardware Wizard to guide you
through the device driver installation.
2
On the Add a New Hardware Wizard window, insert the
Adaptec ATA RAID 1200A floppy disk into the floppy disk
drive. Select Automatic search for a better driver and click
Next
.
3
The following message appears:
Windows has finished installing the new hardware device.
Click Finish.
4
The Adaptec RCM device is detected and the driver is
automatically loaded. Installation is now complete.
Installing the Device Driver for Windows 2000
Installing the Driver When Installing Windows 2000
To install the driver when installing Windows 2000, follow these
steps:
1
Insert the Windows 2000 setup media (floppy disk or CD) and
restart your system to begin the Windows 2000 installation. You
might see the following message:
Press any key to boot from CD.
You will have five seconds to press a key to boot from the CD.
2
When the following message is displayed, press F6 :
Press F6 if you need to install a third party SCSI or RAID
driver...
3
A message will appear after a short time, prompting you to
install your driver. Press S to specify a driver.
ATA RAID 1200A IUG.book Page 5 Wednesday, November 13, 2002 2:22 PM
