H- Adjusting water flow
Mirrored Water Features:
Sometimes when the glass water surface is dirty the water will not cover properly. First, clean the glass
thoroughly. Then, apply a thin coat of the “mirror prep” solution included with your water feature by
simply wiping it onto the mirror. Lastly, with a damp rag or paper towel, wipe off the mirror prep
solution. After you run the water for a short time you may see light streaks. If so shut the water off and
while the water surface is wet wipe it them off.
Baffle:
The Baffle should already be firmly in place and ready to
use. But in the event that it has come loose or it needs to
be removed and replaced for adjusting or cleaning, we
will discuss how it works.
You will notice two sets of copper tabs. The upper set of
tabs is used as handles and to keep the Baffle in place.
The lower set is used to control water flow. To remove or
replace the baffle flatten the upper set of tabs downward
to allow the baffle to roll into or out of the Water
Distribution Unit.
When replacing it; once it is in, be sure it is square to
the Water Distribution Unit, then bend the upper tabs
up until they push against the top lip of the Water
Distribution Unit. Doing this will keep the Baffle
firmly in place and allow the water to flow properly.
