Water Flow:
The Water Distribution Unit and Baffle should be set to allow proper water flow.
In the event the water
does not flow properly please follow the following steps.
First, be sure the Water Distribution Unit is clean. Go over surface of the Water Distribution Unit with the
included Scotch Brite pad.
If there is still any area of the Water Distribution
where water is not flowing properly, adjustments to
the baffle will need to be made. Simply shut off the
fountain, flatten the upper tabs, and remove the baffle
by rolling it up and out of the Water Distribution Unit.
Now you will need to adjust the lower tabs to shift the water to the areas that are dry. These tabs act like
dams controlling where the water will flow. If the center is not getting enough water, pull the tabs down
so they hold more water in the center. Or, to allow more water to one side or the other you can flatten one
or both a little to shift water to either side. You may need to adjust the tabs a few times to get the water to
flow properly.
Before turning the Water Feature back
on, be sure the baffle has been properly
re-installed into the Water Distribution
Unit. Be sure the Baffle is square to the
Water Distribution Unit, then bend the
upper tabs up until they push against the
top lip of the Water Distribution Unit.
Doing this will keep the Baffle firmly in
place and allow the water to flow
properly.
