(1) Using the top center mark, position the wall bracket and mark the slots on the wall.
Take extra
care to insure the wall bracket is level on the wall.
(2) Mount the Bracket.
Use the included lead EZ anchors and 1 inch screws to fasten bracket into the
sheetrock. In the area of a stud use the longer 2.5 inch screws directly into the stud
We recommend fastening into at least one stud.
(Additional assembly for mirror surface)
Because of the possibility of breaking in shipment, the mirror is removed from the frame and packaged
separately. Reinstallation is easy:
1.
Unpack the mirror. Be careful of potential sharp corners and edges.
2.
Remove the 2 screws holding the copper Water Distribution Unit to the rear panel at the top and
remove the unit.
3.
Slide the mirror panel into the groves of the frame until it is all the way down to the plastic liner.
4.
Replace the copper Water Distribution Unit so that the front lip overlaps the glass and reattach
with the two screws
E- Attaching the Pump and cords
The pump comes with two plastic outlet adapters.
(1) Insert the large adapter into the pump
(it will be very snug).
(2) Attach the clear hose to the pump adapter.
Use the included plastic hose clamp to insure a tight fit.
(3) Insert the pump into the lower water tray and feed the attached clear hose and the power cord
to behind the water surface.
These will run up behind the water surface.
(4) Plug the pump in.
The pump should be plugged into one end of the light bar at the top.
(5) Plug the power cord into the other side of the light bar.
If your outlet will be behind the water
feature feed the cord to behind the water surface. If your outlet is beneath the water feature you can feed
the power cord down the open cavity on the right or left side of the water feature.
