23
(5) System Test
Touch the fifth circle, ‘System Test’.
Touch
to start system test.
Touch ‘Test 1: Zone detection’
Touch ‘Start’ and wait until the system finish zone test.
When finished, display will show the number of zones
connected to the system.
a) Shows test result for zoned system
b) Shows test result for non-zoned system.
1
2
3
4
5
NOTE:
Ensure that the number of zones connected to the system is shown on the
zone detection test summary. If not, check for any loose connections or
defective zone motors, then run zone detection test again.
Summary of Contents for QTB-1000
Page 1: ...Installation and Commissioning Manual ...
Page 31: ...31 Notes ...
