Acson international AWSS30A, Technical Manual

Page: 28 / 84

28
Installation For Indoor Unit AWM
Location and Space
Maintenance &
Servicing Space
Air Flow
Direction
nah
T re
hgi
H
leve
L ey
E
50.0 mm
50.0 mm
m
m 0.
05
1
2
3
4
5
Piping Routing
Right & Rear Side Routing
Drain Hose
Fix With Vinyl Tape
Unit Piping
The indoor unit must be installed in such a wayso as to prevent short circuit of the cooldischarged air with the
hot return air. Please follow the installation clearance shown in the figure. Do not place the indoor unit where
there could be direct sunlight shining on it. Also, this location must be suitable for piping and drainage, and
be away from doors or windows.
Routing Of Piping
Remove the screw holding the front panel.
The refrigerant piping can be routed to the unit in a number of ways (left or right from the back of the unit), by
using the cut-out holes on the casing of the unit (see figure). Bend the pipes carefully to the required position
in order to align it with the holes. For the right hand and rear side out, hold the bottom of the piping and then
position it to the required direction (see figure). The condensation drain hose can be taped to the pipes.