Product Name
EK-AI7931LD
Version
E
Doc No
912-13802
Date
2022/11/14
Page
25 / 26
PRODUCT USER GUIDE
www.acsip.com.tw
Integration instructions for host product manufacturers
Applicable FCC rules to module
FCC Part 15.247
FCC Part 15.407
Summarize the specific operational use conditions
The module is must be installed in mobile device.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
and
2) The transmitter module may not be co-located with any other transmitter or antenna
As long as 2 conditions above are met, further transmitter test will not be required. However, the
OEM integrator is still responsible for testing their end-product for any additional compliance
requirements required with this module installed.
IMPORTANT NOTE: In the event that these conditions cannot be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization is no longer
considered valid and the FCC ID cannot be used on the final product. In these circumstances, the
OEM integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization. The OEM integrator has to be aware not to provide
information to the end user regarding how to install or remove this RF module in the user’s manual of
the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this
manual.
Limited module procedures
Not applicable
Trace antenna designs
Not applicable
RF exposure considerations
20 cm separation distance and co-located issue shall be met as mentioned in “Summarize the specific
operational use conditions”.
Product manufacturer shall provide below text in end-product manual
Pro
vid
ed
by
AcS
ip
Pro
vid
ed
by
AcS
ip
Pro
vid
ed
by
AcS
ip
