ACS Marathon MV1012, Operation And Installation Manual

Page: 19 / 49

ACS GROUP Marathon Series Beside-the-Press Granulators Page 19
3 Installation
This chapter contains all instructions required for experienced installation personnel to install the
granulator and prepare it for production. You must follow all instructions carefully and in the
sequence presented. Be sure to observe all
DANGER , WARNING , CAUTION , and NOTE
statements to prevent personal injury or machine damage. These statements are designed to make
installation procedures safe and easy.
3-1 Placing and Installing Your Granulator
1. Make certain the floor is clean, level, and free of obstructions before placing the machine
into position.
2. Visually inspect the hopper in-feed opening to ensure that no stray packing material or
debris is present.
3. Open the machine using the ratcheting tool already attached to the bolt that closes the
cutting chamber. By working the ratcheting tool clockwise, the bolt holding the cutting
chamber closed loosens. The actuator of the red time delay safety switch must be
loosened to open the cutting chamber.
Note that the time delay safety switch is
positioned behind the cutting chamber at the back of the machine. Apply lifting
pressure to the hopper to swing the machine up and back into the fully open position.
4. Open the door to the front of the base. Pull out the bin to ensure it is empty. Spare parts
such as knives or screens (if ordered), are often placed inside the bin for shipping
purposes.
Note: In the extreme open position, the machine is designed to remain open without the use of
any devices. However, a safety latch has been provided to prevent accidental closure of
the machine.
The safety latch is located on the right side of the cutting chamber and should always be
checked to verify that it has fallen into position to keep the machine securely opened.
!
CAUTION
The edges of the cutting chamber and the chamber
knives mounted on the rotor are EXTREMELY SHARP.
Always wear heavy gloves and exercise
care when working in the cutting chamber.