ACS ALCOLOCK LR, Installation Manual

Page: 18 / 72

ALCOLOCK LR
17
2. Connect ECU wire 13 (Brown) to ECU wire 1 (Red).
3. Connect ECU wire 12 (Orange) to the red (positive) alarm horn wire.
4. Use supplied tie wraps to neatly incorporate the alarm horn wires with the
vehicle wire loom. Keep wires away from vehicle components that move, or that
become excessively hot.
14.4 Alarm flasher wire-connection steps (if required)
NOTE: Section 11.0 provides instructions for mounting the alarm flasher and feeding the
alarm flasher wires through the fire wall with a probe.
1. Fasten a ring terminal (21-000022) to the black (ground) alarm flasher wire.
Connect the ring terminal to the same vehicle ground connection used by ECU
wire 8 (Black).
NOTE: The ground connection should look as follows: (This illustration shows a sealed
connection
–
do not seal until the installation is verified. Refer to section 20.0 of this
manual.)
2. Connect ECU wire 13 (Brown) to ECU wire 1 (Red).
3.
Connect ECU wire 12 (Orange) to the red (positive) alarm flasher wire.
14.5 Retest alarm wire-connection step (for hearing impaired)
NOTE:
• Skip this section if a retest alarm (for hearing impaired drivers) is not required
• Section 12.0 provides instructions for mounting the retest alarm (alarm flasher) and
feeding the wires to the ECU cable location
1. Fasten a ring terminal (21-000022) to the black (ground) retest alarm wire.
Connect the ring terminal to the same vehicle ground connection used by ECU
wire 8 (Black).
2. Connect ECU wire 6 (Pink) to the red (positive) wire of the retest alarm.
3. Connect ECU wire 11 (Violet) to the ECU wire 1 (Red).
4. Use supplied tie wraps to neatly incorporate the retest alarm wires with the
vehicle wire loom. Keep wires away from vehicle components that move, or that
become excessively hot.