AcroPack Series AP560
CAN Bus Interface Module
- 14 -
2.
APCe7020E-LF is an example of a carrier that uses the 50-pin Champ connector.
See image of carrier.
3.
The APCe7040E-LF is an example of a carrier that uses the 68-pin Champ
connector. See image of carrier below. On these carriers, pins 26 thru 34 and 60
thru 68 are not connected.
Logic Interface Connector
The AP module logic edge connector interfaces to the mating connector on
the carrier board. The pin assignments of this connector are standard for all
AP modules according to the PCI Express MINI Card Electromechanical
Specification, REV 1.2 (with exceptions shown in Table 2 and noted below).
Power su5, +12, and -12 Volt have been assigned to pins that are
reserved in the mini-PCIe specification.
The ‘Present’ signal is grounded on
the AP module. In addition, COEX1, COEX2
–
wireless transmitter control
signals are reassigned to JTAG signals TMS and TCK. Lastly, UIM_C4, UIM_C8
–
reserved User Identity Module signals are reassigned to JTAG signals TDI and
TDO.
Summary of Contents for AcroPack AP560
Page 28: ...AcroPack Series AP560 CAN Bus Interface Module 28 Figure 2 Standard Data Frame...
Page 30: ...AcroPack Series AP560 CAN Bus Interface Module 30 Figure 3 Extended Data Frame...
Page 32: ...AcroPack Series AP560 CAN Bus Interface Module 32 Figure 4 Remote Frame...
Page 34: ...AcroPack Series AP560 CAN Bus Interface Module 34 Figure 5 Error Frame...
