Acom 700S, Operating Manual, Page: 29 / 30

29
* Extensions or changes of the frequency coverage are possible on request.
** Please refer the applicable region bandplans and laws for specific allocations and limitations.
b) Rated output power: 700W +/-0.5dB, PEP or continuous carrier.
c) Intermodulation distortions (IM3): better than 31dB below the rated PEP.
d) Harmonic and parasitic emissions output suppression: better than 60dB (65dB typically).
e) Input and output impedances:
- nominal value: 50 Ohm unbalanced, UHF (SO239) type connectors;
- input circuit: broadband, SWR below 1.2:1 (1.1:1 typically); 1.8 – 54 MHz continuous range
without retuning or switching;
- RF by-pass path SWR - below 1.1:1, 1.8-54 MHz;
- acceptable SWR at the output load (the antenna): up to 3:1 with proportional power reduction
and up to 1.5:1 for full output power;
f) RF power gain: 14dB +/-1dB (typically 27W for 700W output power);
g) Mains power supply voltage: 100-240VAC (see 7.2 Replacement of fuses for correct fuse rating
and mains voltage range selection).
h) Mains power consumption at full output power: 1350VA or less with a power factor of 0.95 or
higher;
i) Mains power consumption in Low Energy (waiting) mode: less than 1VA;
j) Complies with EU safety regulations and electromagnetic compatibility standards, as well as
k) with the US Federal Communications Commission (FCC) rules;
l) Environmental conditions:
- temperature range: -10ºC to +40ºC (14ºF to 104ºF);
- relative air humidity: up to 95% @ 35ºC (95ºF);
m) Dimensions (projections not included) and weight, operating: (W x H x D) 326 x 143 x 365 mm
(12.8 x 5.6 x 14.2 In); 11.8 kg (26.00 Lbs).
8-2. Functions
a) Receive / transmit control:
- KEY-IN input – Phono RCA jack; voltage applied to the transceiver keying output up to +12V;
current drawn by the transceiver keying output up to 6mA;
- An optional KEY-OUT output – Phono RCA jack; output resistance: not more than 120 Ohm;
maximum safe input voltage from the trans50V; maximum safe current drawn by the
transceiver: 20mA;
- minimum dead time, necessary for safe amplifier switchingover from receive to transmit: 10ms
between the transmit request on the KEY IN input and the RF drive on the RF INPUT jack.