
13
Fig. 3-2 Basic screen
b) Operating values and alarm messages area.
Any two operating values selected in the AMP MEASURE menu (S. 5-1) will be shown here.
The alarm messages (either WARNING or SOFT FAULT) appear on yellow background on the same
area and are flashing frequently in order to attract the operator’s attention (Fig. 4-1).
The WARNING messages appear only temporarily (for about three seconds), afterwards the indication
of the operating values is restored automatically (S. 4-4(a).
The SOFT FAULT messages appear in the same field but they remain on the screen until the AUTO
OPERATE time is elapsed (S.4-1(c)) or until the operator pushes any button, then the operating values
indication is restored too.
c) Working mode indicator - OPR, STB or AUTO OPER (S. 4-1).
d) RX/TX indicator - reads the request for transmit (KEY-IN input). The RX indication is green and
the TX is red. The indicator will flash frequently if switch over is impossible.
e) Forward power bargraph and digital readout. Displays the power fed into the antenna.
f) Reflected power bargraph and readout. Entering the red zone is not allowed.
g) PA transistor temperature bargraph and readout. Entering the red zone is not allowed.
h) CAT interface information. When CAT is deactivated, this field is shaded.
i) REMOTE CONTROL information field–flashing represents RS232 port dataflow.
Summary of Contents for 700S
Page 1: ...OPERATING MANUAL ...