2
Chapter 1
•
Capacity support:
•
1GB/2GB/4GB DDR3 1.5V 1333/1066 Un-buffered Non-ECC DIMM support.
•
1 GB to 8GB Max memory support(using 4Gb tech).
•
DDR3 1.5V 1066/1333.
•
Design Criteria:
•
Should meet Intel Sandy Bridge Family design guide.
•
Support 1.5V DIMM.
•
Dual channel should be enabled always when plug-in 2 same memory size DDRIII memory
module.
•
Follow Intel design guide and spec.
Hard disk drive
•
Support SATA interface.
•
3.5”, 25.4mm, 80/160/320/500/640/1TB/2TB G or higher capacity.
•
5400/7200 rpm or higher".
•
Capacity and models are listed on AVLC.
Optical disk drive
•
Support SATA 5.25” standard ODD.
•
Support DVD-ROM, DVD-SuperMulti (Label Flash), BD-DVD, BD-Combo. BD-RW.
•
Capacity and model is listed on AVLC.
Graphics
•
Intel® HD Graphics Support
•
Dual independent display
•
Digital display (HDMI/DVI/DP/eDP) and VGA
•
DVMT 5.0 technology support
•
Enhanced 3D and Clear Video technology support
•
1 D-sub VGA port on rear
•
1 DVI-D port at rear side
•
Dual View function support
•
Need to measure VGA follow Acer VGA SOP
•
Monitor compatible is requested to the monitor AVL and DQM recommended list
Graphics card support
•
No mechanical retriction to support for double slot, full length graphics cards in the single PCIe X16 slot.
Serial ATA controller
•
Slot Type: SATA connector
•
Slot Quantity: 3(H61 without 6Gb/s)
•
Storage Type support:
•
3.5” SATA/SATAII/SATAIII HDD
•
Combo/ DVD supermulti/Blue-ray DVD ODD
•
RAID/AHCI/IDE mode option
•
IDE mode for H61.
Summary of Contents for Veriton X2610
