Chapter 1
3
LAN
•
Controller: Intel 82579V Gbt LAN controller/PHY.
•
RJ-45 Back panel port with Link/Activity LEDs.
•
Need support Wake up on LAN function.
Audio
•
Chip : HD audio codec ALC662-VC HD codec 5.1
•
Connectors support:
•
Rear 3 jack follow HD audio definition (ALC662-VC).
•
Audio jacks color coding: should meet Microsoft Windows Logo Program Device Requirements:
Audio-0002.
•
1 front panel audio header (2*5).
•
1 internal speaker header (2*4).
•
S/N ration: 90dB at rear output jack.
•
1 front panel audio header (2*5).
•
Follow Acer Audio spec v4.1 & audio C/R should support Acer Internal speaker spec.
•
BIOS should meet MS Pin Configuration Guidelines for High Definition Audio Devices.
•
HD Audio de-pop CKT.
•
One earphone and one microphone jack is required on front bezel.
•
One 4pin SPDIF internal header closed to PCIEx16 slot.
•
Auto detection and re-tasking behavior is following Acer Audio Jack spec.
USB ports
•
Controller: 6 Series Express Chipset (Cougar Point).
•
Ports Quantity: 10
•
6 back rear ports(USB2.0 * 6 ports, USB 3.0*2 reserve for BOM option, default w/o USB3.0).
•
On-board: two 2*5 headers.
•
4 ports for front daughter board.
•
4 ports reserved.
•
Connector Pin: standard Intel FPIO pin definition.
•
Data transfer rate support:
•
USB 2.0/1.1 (3.0 by BOM option).
•
All USB ports must be boot-capable includes USB-ODD, USB-HDD, USB-FDD, and etc…
•
All USB ports must provide the over current protection.
•
The pin connector should be located on upper if Virginia is placed on horizontal.
Extension slot
•
1 * PCIE x16 (PCIE V2.0)
•
1 * PCIE x1 (PCIE V2.0)
Buzzer
•
1 on board buzzer
Summary of Contents for Veriton X2610
