Acer TravelMate 4730 Series, Service Manual

Page: 37 / 194

Chapter 2 27
Main
The Main screen allows the user to set the system time and date as well as enable and disable boot option
and recovery.
NOTE: The screen above is for your reference only. Actual values may differ.
The table below describes the parameters in this screen. Settings in boldface are the default and suggested
parameter settings.
NOTE: The sub-items under each device will not be shown if the device control is set to disable or auto. This is
because the user is not allowed to control the settings in these cases.
Parameter Description Format/Option
System Time Sets the system time. The hours are displayed with 24-
hour format. Format: HH:MM:SS
(hour:minute:second)
System Date Sets the system date. Format MM/DD/YYYY
(month/day/year)
Total Memory This field reports the memory size of the system.
Memory size is fixed to 3017 MB. N/A
Video Memory Shows the video memory size. VGA Memory size=32 MB N/A
Quick Boot Allows startup to skip certain tests while booting,
decreasing the time needed to boot the system. Option: Enabled or Disabled
Network Boot Enables, disables the system boot from LAN (remote
server). Option: Enabled or Disabled
F12 Boot Menu Enables, disables Boot Menu during POST. Option: Enabled or Enabled
D2D Recovery Enables, disables D2D Recovery function. The function
allows the user to create a hidden partition on hard disc
drive to store operation system and restore the system
to factory defaults. Option: Enabled or Disabled
SATA Mode Control the mode in which the SATA controller should
operate. Option: AHCI or IDE Mode
InsydeH20 Setup Utility Rev. 3.5
Information Main Advanced Security Power Boot Exit
Item Specific Help
System Time [13: 04:04] This is the help for the
System Date [06/04/2008] hour field. Valid range
is from 0 to 23.
Total Memory 4095 MB INCREASE/REDUCE : F5/F6
Video Memory [256MB]
Quick Boot [Enabled]
Network Boot [Enabled]
F12 Boot Menu [Enabled]
D2D Recovery [Enabled]
SATA Mode [AHCI]
F1 Help
↑↓
Select Item F5/F6 Change Values F9 Setup Default
ESC Exit
←→
Select Menu Enter Select
X
SubMenu F10 Save and Exit