Diagnostic Utilities
2-22
3.
Windows Security
pop-up warning appears, click on
Install this driver software
anyway
.
Figure 2-39. Warning Message
NOTE:
Make sure not close the Command Line interface until the driver installation is complete.
4.
Wait until the driver is installed and the
Install Complete!
status appears on Command
Line interface as follows.
Figure 2-40. Driver Installation Is Complete
5.
Double-click to open the “
gsensorconfig.txt
” in a text editor and configure the GSensor
Calibration specification as follows: (The values should be higher than 0.4).
•
GSENSORMISAGAINX=
<
0.5
>
•
GSENSORMISAGAINY=
<
0.5
>
•
GSENSORMISAGAINZ=
<
0.4
>
6.
Enable the USB debug mode on PAD.
7.
Connect the PAD to the PC via MicroUSB cable.