Chapter 2
25
IDE HDD Auto-Detection
Press <Enter> while this item is highlighted to prompt the Setup Utility to automatically detect and
configure an IDE device on the IDE channel.
NOTE:
If you are setting up a new hard disk drive that supports LBA mode, more than one line will appear in
the parameter box. Choose the line that lists LBA for and an LBA drive.
IDE Channel 0/1/2/3 Master/Slave IDE/Extended IDE Drives
Leave this item Auto to enable the system to automatically detect and configure IDE devices on the
channel. If it fails to find a device, change the value to Manual and then manually configure the
drive by entering the properties of the drive in the items described below. Please note that if you
choose IDE channel 2/3 Master, the item may change to Extended IDE drive.
Access Mode
This item defines ways that can be used to access IDE hard disks such as LBA (Large Blocking
Addressing). Leave this value Auto and the system will automatically decide the fastest way to
access the hard disk drive. If you choose IDE channel 2/3 Master, the item only has Large and
Auto.
Drive A
The item defines the properties of any diskette drive attached to the system. You can connect one
or two diskette drives.
Summary of Contents for Aspire E650
Page 2: ...II PRINTED IN TAIWAN ...
Page 16: ...6 Chapter 1 Main Board Placement ...
Page 83: ...73 Chapter 6 Exploded Diagram ...
