Acer Altos G520 series, User Manual

Page: 141 / 186

131
The add-in adapter stopped working without apparent cause.
• Try reseating the adapter first; then try a different slot if necessary.
• The network driver files may be corrupt or deleted. Delete and
then reinstall the drivers.
• Run the diagnostics.
System Boots when Installing PCI Card
System Server Management features require full-time “standby”
power. This means some parts of the system have power going to
them whenever the power cord is plugged in, even if you have turned
the system power off with the power button on the control panel. If
you install a PCI card with the AC power cord plugged in, a signal may
be sent to the command the system to boot. Before installing a PCI
card, you should always:
• Turn off the server power by using the power button on the front
of the system.
• Unplug the AC power cord(s) from the server.
Problems with Newly Installed Application
Software
Problems that occur when you run new application software are
usually related to the software, not the server hardware. Faulty
equipment is unlikely, especially if other software runs correctly.
Check the following:
• Make sure the system meets the minimum hardware requirements
for the software. See the software documentation.
• Make sure the software is properly installed and configured for
the system. See the software documentation.
• Use only an authorized copy. Unauthorized copies often do not
work.
• If you are running the software from a diskette, CD-ROM or DVD-
ROM, try a different diskette.
• Make sure the correct device drivers installed.
If the problems persist, contact the software vendor’s customer service
representative.
BB!H631!.!FO/cppl!!Qbhf!242!!Uvftebz-!Bvhvtu!28-!3115!!5;13!QN