Altos 12000 Series User’s Guide
clxvi
3.
Perform a SCSI low-level format with the Format Disk utility under SCSI
Disk Utilities in the SCSISelect utility.
All data on the target drive will be lost when
you run the Format Disk utility. Back up your
data before you run it!
4.
In the SCSISelect Advanced Configuration Options menu, set Extended BIOS -
Translation to Enabled.
5.
Partition the drive again.
6.
Restore data to the drive, if necessary.
5.5.1
Device connected, but not ready
This message appears if the SCSI controller receives no answer when it requests
data from an installed SCSI device. The SCSI controller skips this device and
moves on to the next device on the bus.
Do the following if you see this message when you request data from a SCSI
drive:
1.
Run the SCSISelect utility and access SCSI Device Configuration. Locate the
host controller's SCSI ID and set Send Start Unit Command to yes.
2.
Exit the SCSISelect utility and request data from the drive again.
3.
If the message still appears, follow the drive manufacturer's instructions to
make sure the drive is set to spin-up when the power is switched ON.
Summary of Contents for Altos 12000 Series
