3
6
STARTER MOTOR INSTALLATION
• Apply some oil on the dust seal.
• Install the carbon brush on the carbon brush base.
• Apply a little oil on the moving part of the armature ends.
• Put the carbon brush into the bracket, and then install the
carbon brush base.
Do not damage the contact area of the carbon brush
and the armature. When installing, do not damage
the lip of the dust seal.
• Mount the new O-ring on the carbon brush base.
• Install armature into starter motor case, making sure
not to damage the carbon brushes.
• Tighten motor case bolts.
Make sure the starter motor case is free of metal
particles because it is magnetic.
%HIRUHLQVWDOOLQJWKHVWDUWHUPRWRURQWKHYHKLFOHDIWHUDVVHPEOLQJLW¿
rst
connect the lead wires and check that the motor is running normally.
• Apply oil on the O-ring, and install the starter motor.
• Tighten holding bolts.
Summary of Contents for Maxxam 150 2R
