MFT1x_Kurzübersicht_Brief Overview_V2.22_de_en
14 / 23
9 Unpacking
Package contents:
Device
Brief overview
Power s
upply cable or table power adapter, depending on the customer’s preferences
Check that all components are undamaged and that all package contents are present.
10 Intended Use
The MFT10/MFT12/MFT15 serves as a terminal, specifically designed for use in vehicles such as forklifts or
order pickers. Do not use the system in explosive areas.
The supplied components are intended for use with this device only.
11 Safety Notes and Warnings
Please read the following information. It serves to ensure your safety as well as the operational readiness of
the device.
ATTENTION
Tampering with the device or improper operation will lead to a loss
of warranty! If problems occur, ACD must be asked for their
decision in order to send in the device for repair at their premises.
ATTENTION
The device may only be opened by trained specialists, and only
after consulting with ACD.
ATTENTION
The MFT10/MFT12/MFT15 is equipped with a rechargeable lithium
ion battery pack. Lithium ion battery packs can explode if exposed
to fire. The battery pack must not be disassembled and exposed to
fire or heat (greater than 60 °C (140 °F). The battery must not be
charged externally via an external charger, but only via the table
power adapter provided by ACD or the vehicle’s power supply.
Since the battery pack is plugged inside the terminal (no spare
battery), the battery pack may only be changed by ACD or by ACD
trained service staff. Devices or battery packs which are no longer
used must be disposed of as toxic waste or returned to ACD
(WEEE directive)
ATTENTION
The power supply is electrically isolated from the device.
Please bear in mind, however, that this electrical isolation ceases
to be effective if the interfaces (COM/USB) of the device are
directly supplied with input voltage (without electrical isolation).
This can lead to the destruction of components of the device.
ATTENTION
Only original ACD power packs or the ACD power supply cable
may be used for operating the MFT10/MFT12/MFT15. Please
observe the input voltage range on the rating plate located at the
rear of the device.
