Manual Part # 800-1402-002 Rev K, 072418
Page 25 of 53
Hold
The Readout provides a feature that allows the displayed
measurement or
position to be “held”. This allows information
to be captured on the Readout and held for later viewing
regardless of the current Encoder position.
To activate the HOLD,
Momentarily
press the
F4
key.
HOLD
will be displayed
in the upper left corner of the LCD. The currently displayed position and
selected key presses will be held.
To release the HOLD feature,
Momentarily
press the
F4
key again, or cycle
power.
NOTES:
•
If power is cycled when HOLD is active, any key (such as
UNITS
,
DATUM
,
+
or
–)
that is depressed while in HOLD will be executed
when power is restored.
•
Leaving the normal measurement mode, (i.e. enter programming
mode, SEND, or using the Go/No Go editor) causes the Readout to
automatically exit HOLD.
Delete
Momentarily
pressing
F2
sends a special “
delete
” signal to the
output data port. When a ProRF Transmitter is attached to this
port, a “
delete
” message will be sent to the ProRF Receiver.
This “
delete
” message removes the last measurement from a cut list when
connected to another device such as an automated stop or cutting system.
