Operation Manual for LCD Digital Readouts
Page 12 of 53
S
ECTION
2
I
NSTALLATION
Mounting the Readout
Basic , 950, General Purpose
These Surface Mount Readouts may be mounted:
•
Using Velcro or Double sided tape applied to the back side
•
Drilling out the 3 holes (see below) from the inside of the case
•
Using any of the six holes on the back of the case (M2 or 4-40 screws)
¼ DIN In-Panel
A cutout should be made in the panel at least 90mm x 90mm (3.6 x 3.6 inches),
but no larger than 93mm x 93mm (3.7 x 3.7 inches).
The cases of the Readout are designed to "sandwich" panel thicknesses
between 3mm (0.125") and 20mm (0.750").
NOTE
: If the panel is thinner than 3mm (0.125 in), shorter screws must be
used for the Readout casing or damage to the front cover of the Readout will
occur.
