Accurate Technology Model 8, Installation Manual

Page: 93 / 132

MAINTENANCE
Operate the projector at the voltage indicated on the line voltage indicator. Do not
overload power outlets and extension cords as this can result in fire or shock hazards.
The projector is equipped with a three wire plug having a third (grounding) pin. This is a
safety feature. If you are unable to insert the plug into the outlet, contact an electrician to
have the outlet replaced. Do not defeat the safety purpose of the grounding-type plug.
Ventilation Slots >
Slots and openings in the projector provide ventilation. To ensure reliable operation of
the projector and to prevent overheating, these openings must never be blocked or
covered. The projector should never be placed near or over a radiator or heat register. The
projector should not be placed in an enclosure unless proper ventilation is provided.
Do not push objects of any kind into the projector through the ventilation openings. They
may touch dangerous voltages or short-out parts resulting in a fire or shock hazard. Do
not spill liquids of any kind into the projector. Should an accidental spill occur,
immediately unplug the projector and have it serviced by a qualified service technician.
Servicing >
If any of the following conditions exist, unplug the projector from the power outlet and
refer service to qualified service personnel.
- The power cord has been damaged.
- Liquid has been spilled into the projector.
- The projector has been exposed to excessive moisture.
- The projector does not operate normally.
- The projector has been dropped or the case has been damaged.
- Projector performance has deteriorated.
Do not attempt to service the projector yourself. All servicing must be performed by a
qualified Accurate Imaging service technician. If replacement parts are required, it is
important that only Accurate Imaging approved parts are used. Other parts may result in
fire, electric shock or risk of personal injury.
WARNING: THE PROJECTOR IS INTERNALLY SHIELDED TO PROTECT THE
USER FROM EXPOSURE TO SOFT X-RAY RADIATION. IMPROPER SERVICING
OR SHIELD REMOVAL MAY RESULT IN PERSONAL INJURY.
ACON >
In rare instances, flashing lights can trigger an epileptic seizure. During
ACON usage persons with epilepsy should look away from the screen.
4.2 Cleaning
Clean the projector when required. Before cleaning, always unplug the Projector from the
power outlet.
Lens Cleaning >
To avoid the risk of scratching the lenses, only clean the lenses if absolutely required. A
small amount of dust on the lenses will have very little effect on picture quality. If the
lenses must be cleaned, use a DRY soft cotton cloth. Rub gently in a circular motion.
4-2