Accu-Steam EG24A, Installation & Operator'S Manual, Page: 27 / 48

Accu-Steam™ G2 Electric Installation and Operators Manual
MP5018-1702
PAGE 24
OPERATION
Press the ON/OFF switch (See FIG 7) and
the griddle will start to pre-heat and
LED 1
will
blink Any time the appliance is turned on it will
operate and heat to the default set temperature
or the last regulated Non-Preset temperature.
( Factory default is 350°F )
The display will show the current temperature
until the set temperature is met, then
LED 1
will go
solid. (See FIG 4) The display will go to a “ rdY ”
display or show the set temperature depending on
the programming when the appliance was initially
installed and setup. (Factory default is “ rdY ” )
PRESETS
Press the ON/OFF switch (See FIG 8) and
the griddle will start to pre-heat and
LED 1
will
blink .
Press and hold any
PRESET KEY or
for three seconds or until the LED 2 or LED 3
blinks.
The selected preset LED will blink and the display
will show the current temperature and increase or
decrease depending on the set temperature until
it has reached the set preset temperature for that
preset key and then go solid and The display will go
to a “ rdY ” or show the set temperature depending
on the programming when the appliance was
initially installed and setup. The set display
temperature will remain at the set temperature
until the griddle is turned off and back on.
The factory defaults for the preset keys are:
070F
350F
Please use caution as temperatures on and around the griddle
cooking surface could cause severe burns.
375°F
400°F.
Fig. 7
Fig. 8