Accu-Steam EG24A, Installation & Operator'S Manual, Page: 15 / 48

Accu-Steam™ G2 Electric Installation and Operators Manual
MP5018-1702
PAGE 13
PAGE 1
MP5020-1612
ELECTRIC - ACCU-STEAM™ Installation/Operational Checklist & Warranty
Registration Form
Store/Location:
Address:
City: State: Zip:
Phone Number: Fax Number:
Email:
Model # Serial #
Name of Service/Installer Company:
Technician: Phone Number:
** AccuTemp Products, Inc. is not responsible for the installation and/or modifications to the electrical supply source. **
Failure to accurately complete and provide this Installation/Operational Checklist & Warranty
Registration Form to AccuTemp Products may delay or void future Warranty Service Calls.
Check-Off List
General:
Electrical Connection :
Yes No
Yes No
Yes No
Yes No
Yes No
AMPS
Yes No
NEMA 15-50P 208/240VAC (All Models)
NEMA L16-20P 440/480VAC (24” Model)
NEMA L16-30P 440/480VAC (24” Model)
IEC 60309 IP44 380 VAC (5 wire 4 Pole)
Is the electrical wall receptacle positioned in a low heat-zone?
Note: It is recommended that the wall receptacle be
placed as low as State & Local codes allow. Placement in high heat-zones could cause damage to the electrical cord or plug
that would not be covered under the product warranty.
Is the griddle level, both side-to-side and front-to-back?
If this is a table-top installation, have the (4) rubber foot tip/boots been installed?
Is the Supply Power Cord being plugged into a
wall outlet?
Yes No
Is the Supply Power Cord being hard-
wired, without the plug, to a breaker
Is the Supply Power Cord properly connected to GND?
What is the Electrical Breaker Amperage that will interrupt the Supply Voltage to the electric griddle?
Is the correct Plug and Receptacle being used on the Supply Power Cord?
Type of Plug?