AccessECU 2005, User Manual

Page: 9 / 70

Step 2: Step 2:
Step 2: Step 2:
Step 2:
Use the supplied Initialization Connector (BLUE for 2002 vehicles, WHITE for 2003-
2005 vehicles). Attach the Initialization Connector to the complementary whitish
(semi-clear) factory connector located in close proximity to the green Test Mode
connectors. It may be difficult to find but this connection is required, please use
patience.
Step 3: Step 3:
Step 3: Step 3: Step 3:
Turn the ignition key to the ‘ON’ position but DO NOT start the engine. Verify the
Check Engine light on your dash is blinking. You may also hear the radiator fans
cycling on/off as well as the fuel pump cycling, etc. THIS IS A NORMAL FUNCTION
OF TEST MODE. If your vehicle is not displaying a flashing Check Engine Light,
please refer to page 47 for additional steps before continuing.
Step 4: Step 4:
Step 4: Step 4:
Step 4:
Connect the DiagPORT cable (D-sub 9-pin) to the complementary connector on
the AccessPORT.
Step 5: Step 5:
Step 5: Step 5: Step 5:
Connect the red end of the supplied DiagPORT cable to the diagnosis port con-
nector located in the lower portion of the dash (below the steering wheel). The
AccessECU logo will be facing you (up). Make sure connection is firm and secure.
2002 Initialization 2002 Initialization 2002 Initialization 2002 Initialization 2002 Initialization
Connector (BL Connector (BL
Connector (BL Connector (BL
Connector (BLUE) UE)
UE) UE)
UE)
2003-2005 Initialization 2003-2005 Initialization 2003-2005 Initialization 2003-2005 Initialization 2003-2005 Initialization
Connector (WHITE) Connector (WHITE)
Connector (WHITE) Connector (WHITE) Connector (WHITE)
9