Access Virus TI, User Manual

Page: 65 / 218

65 VIRUSCONTROL
FILTER Page
This is where you will find all the controls relating to the filter
(duh!) and the amplifier section.
The two large dials represent the filters of the Virus TI, with a
graphical representation of the cutoff frequency and resonance
level. Just like the equivalent control on the Easy Page, you can
control Cutoff with the outer dial and Resonance with the sepa-
rate, dedicated controller. Alternatively, you can grab the little
red square with the mouse pointer and sweep both simultane-
ously - definitely the cooler option!
Click the little silver button between Env Amt and Vel to switch
the polarity of the filter envelope modulation.
Grab and drag the keyboard graphic to adjust the keyfollow
base key.
FILTER LINK button
This button links the Resonance, Env Amt and Keyfollow con-
trols for both filters, whereby adjusting one snaps the equivalent
parameter in the other filter to the same value. This is essentially
the same as pressing both Filt1 and Filt1 Select buttons on the
TI hardware.
Envelopes
There are two ways to adjust the envelope stages – you can
either turn the knobs, or grab and drag the little red squares.
Note that depending on which stage you wish to adjust you
must drag the square either vertically or horizontally:
For a full description of any parameter, simply manoeuvre the
mouse pointer over it, and take a look at the Information Bar
along the bottom of VirusControl.