Access RPSP, Installation Manual, Page: 40 / 60

39
Installation Manual – RPSP
INS-RPSP-EN-05
4.6 Call devices
The machine is equipped with two radio call devices. Open the call boxes and position them on the wall or a
part of it with the dowels provided. The call boxes must be positioned at the two ends of the guide.
Caution! The call boxes are not identical. The “left” call box must be positioned at the left end of the
guide (looking at the machine from the front) and the “right” vice-versa
The presence of some components may vary based on the intended market and on current
standards.
How to distinguish the two call boxes is shown in Figure. The park symbol must always face the guide.
Left
Right
Fig. 53 - Details of call box assembly
The call box located in line with the guide top stop
must be recognised by the machine command
system.
This recognition is performed by acting on the
jumper in the box.
Only the upper call box needs this customisation.
Fig. 54 - Jumper
The call equipment (call box and radio control) is
powered by the radio receiver (RFPcb) located on the
motherboard inside the machine.
Ensure that the dip-switch on the device boards
have been set in the same way as the dip-switch on
the receiver.
Fig. 55 - Radio control board (Dip-switch detail)
Jumper JP1