Access RPSP, Installation Manual, Page: 38 / 60

37
Installation Manual – RPSP
INS-RPSP-EN-05
If the operation has been performed correctly, the
D14 LED will light up on the board.
Fig. 48 – Switching ON of D14.
 Take the remote control (TX module) to the
maximum distance desired and push any of the
commands, ascend or descend (the D14 led will
switch off).
Fig. 49 – Press any command to calibrate the maximum operating distance.
 When the procedure is complete put the dip
switches back in their original position on the
receiver (the position must be the same as the
transmitters, in the absence of other nearby
systems the standard configuration is with both
in the OFF position).
The set distance will be indicative as the radio
system changes its behaviour when the
environmental conditions change.
OFF
Fig. 50 – standard configuration
4.4.3 Onboard Alarm
This is situated inside of the body of the machine and
has been pre-installed in the factory by connector E
Fig. 51 – Onboard Alarm Connector
LED D14