Accent 1400 Hardware Manual for Dedicated Devices
Page 28
The NuPoint module is ready to set
up for use. For detailed instructions
on customizing settings, refer to the
NuPoint Getting Started
guide.
Mounting a NuPoint Module
Important!
The NuPoint module must be securely attached to the device with all screws to operate properly.
If you purchased NuPoint with your Accent device, the NuPoint module is already mounted on the device.
If you purchased NuPoint later, follow these instructions to attach the module to the device. You can
attach the module to a device with or without a frame.
Note:
Your device may look slightly different from the device shown in these photos.
1.
Remove the device handle or port cover. See “Removing or Reattaching the Handle” on page 16 or
“Attaching the Port Cover” on page 17. You will use the screws you remove from the handle or port
cover to fasten the NuPoint module to the device.
Important!
If the device has a frame attached, remove the two top screws that hold the frame in
place. Otherwise, the NuPoint module will not mount properly. Store these screws in a safe location
or discard them.
Loose screws can be a choking hazard.
2.
Align the connector and screw holes on the NuPoint module with the NuPoint USB connector and
screw holes on the top edge of the back of the device.
3.
Slide the module into place, making the sure the connectors are engaged completely.
4.
Tighten the two screws you removed in step 1 to secure the module to the device.
